Skip to main content
 

TRAILERS & TRAILER ACCESSORIES

MOTORIZED SCOOTER- HITCH MOUNTED CARRIER

Where to find MOTORIZED SCOOTER- HITCH MOUNTED CARRIER in West Lafayette

Image for reference only
Actual item may look different
Click on image for larger view

Model: SC400-V2

Daily: $53.00

Weekly: $161.00

Quantity: for a period of  
day(s)   week(s)  

Additional Information

  • Universal design can be used with most power wheelchairs and scooters
  • Integrated solid ramp for quick loading and unloading
  • Quick action spring pull pins secure the ramp for transport in the folded flat or vertical positions
  • Carrier can be folded up flat vertically against the rear of the vehicle saving space when not in use
  • Tough black powder coating protects against dust, dirt, & debris from the road
  • Tested 400 lb weight capacity
  • Rack weighs only 65 lbs
  • Steel expanded mesh surface with raised 3-1/8" side rails
  • 11 total tie down points (tie-down straps not included)
  • Quick and easy 5 bolt assembly
  • Includes an anti-tilt locking device to prevent the rack from wobbling
  • 2 small rear reflectors included for added visibility when using at night
  • For use with 2" Class III or IV trailer hitches
  • Not for use with 1-1/4" hitches
  • Warning and Usage Guidelines
  • Carrier Carrying Capacity: The SC400 carrier is designed to safely carry 400 lbs
  • Hitch Weigh Limit: Most Class III hitches are rated for 500 lbs - Most Class IV hitches are rated for 1,000 lbs
  • Vehicle Hauling Capacity: Your hauling weight may be limited by your vehicle's capacity to carry a load
  • Will not work with Class II or smaller receivers
  • Some vehicles may require air shocks or heavier springs to stiffen up the suspension to prevent sagging
  • Please check with your dealer to find out your vehicle's carrying capacity
  • NOT recommended for tow-behind trailers including 5th wheel trailers and camping trailers
  • NOT recommended for use with hitch adapters/extensions
  • NOT designed to carry scooter or wheelchair while occupied
  • Maximum scooter or wheelchair width is 27" wide
  • 1. SLIDE ANTI-TILT LOCKING DEVICE TIGHT UP AGAINST HITCH RECEIVER, INSERT HITCH PIN OR PINCH BOLT AND TIGHTEN BOLTS USING 17MM WRENCH.
  • 2. INSERT CARRIER INTO HITCH AND INSTALL THE PINCH-BOLT ASSEMBLY. (BOLT-> SLEEVE-> HITCH-TUBE -> WASHER-> NUT)
  • 3. TIGHTEN HEX HEAD PIVOT BOLT WITH 10mm ALLEN WRENCH TO ELIMINATE SIDE TO SIDE WOBBLE OF THE HITCH CARRIER. DO NOT OVER-TIGHTEN. IF BOLT IS OVER-TIGHTENED CARRIER WILL NOT BE ABLE TO PIVOT OR SWING UP.
  • 4. ADJUST LEVELER BOLT TO ALIGN PIN HOLES. PIN SHOULD BE ABLE TO BE REMOVED/ INSTALLED WITHOUT BINDING IF PROPERLY ADJUSTED. TIGHTEN JAM NUTS WHEN PROPERLY ALIGNED USING 17mm OR 11/16" WRENCH.
  • 5. REMOVE PIN TO FOLD CARRIER VERTICAL. REPLACE PIN IN TOP PIN HOLE TO SECURE CARRIER IN THE VERTICAL POSITION.

* Prices are subject to change. Tax and other fees not shown in above price estimate.